Rauch AXIS-M 20.2 EMC, Инструкция по эксплуатации

Страница: 200 / 236

Spreading operation B
180
AXIS
AXIS
50.2
B.10 Discharging residual material
To maintain the value of your machine, discharge the hopper immediately after
every use. Proceed as with the calibration test to discharge the residue. See the
sub-chapter of the respective type.
Instructions for completely discharging the residual material:
Small amounts of fertiliser may remain in the machine when discharging residual
material normally. If you wish to discharge the residual material completely (e.g.
at the end of the spreading season, when changing spreading material), please
proceed as follows:
1. Empty the hopper until no more spreading material comes out (normal dis-
charge of residual material).
2. Switch off the PTO and the tractor engine and lock them to prevent unauthor-
ised starting. Remove the ignition key of the tractor.
3. While the metering slide is open, move the drop point back and forth (position
0 to 9 and back).
4. Remaining fertiliser can be removed with a soft water jet when cleaning the
machine;
See also “Cleaning“ on page 207 .
n
WARNING
Risk of injury due to rotating machine components
Rotating machine components (universal drive shaft, hubs) may
catch and pull-in body parts or objects. Contact with rotating
machine components may cause bruises, abrasions and crushing
injuries.
 Always stay outside the area of rotating hubs while the
machine is running.
 When the drive shaft is rotating, the metering slides are to
be operated from the tractor seat
at all times .
 Ensure that nobody is present in the hazard zone of the
machine.

Set the drop point to position 0 .
Kg
K
D
C
Q
W
R