Maintenance and repair
113
9
9.12
Maintenance of the hydraulic system
The hydraulic system of the AXIS H EMC mineral fertiliser spreader consists of
the following components:
Hydraulic block with oil supply from the tractor,
Hydraulic motors,
Connection hoses.
Within the hydraulic circuits, the drive components and the control elements are
all connected with each other via hydraulic lines.
During operation, the hydraulic system of the mineral fertiliser spreader is subject
to high pressure. During operation, the temperature of the oils in the system is
approx. 90 °C.
n
WARNING
Risk of injury due to the hydraulic system
Hot fluids and fluids escaping under high pressure may cause
severe injury.
Before starting any work, the hydraulic system is to be
depressurised.
Switch off the tractor engine and secure the tractor against
restart.
Let the hydraulic system cool down.
When searching for leakage, wear protective goggles and
protective gloves at all times.
n
WARNING
Risk of infection caused by hydraulic oils
Hydraulic oils escaping the system under high pressure may pen-
etrate the skin and cause infections.
In case of injury in connection with hydraulic oil, immedi-
ately seek medical attention!
Содержание AXIS H EMC Series
