Rauch AXENT Series, Руководство оператора

Страница: 60 / 170

Commissioning 6
54
6.4 Adjusting the end stop of the steering axle to the wheel size
The steering axle of the machine is equipped with a suitable number of spacers
ex works. Thus, the stop of the steering angle is pre-set.
6.5 Installing the universal drive shaft on the machine
6.5.1 Installing/removing the universal drive shaft
Installation:
1.
Check the installation position.
 The end of the universal drive shaft indicated by the tractor symbol is
facing the tractor.
NOTICE
If you want to equip your machine with a different track or wheel size, the number
of spacers must be adjusted. In this case, contact your specialist workshop.

Only the specialist workshop may carry out retrofitting work on the steering
axle.
n
CAUTION
Material damages due to unsuitable drive shaft
The machine is delivered with a drive shaft that is designed according
to the device and performance.
The use of incorrectly dimensioned or inadmissible drive shafts, for
instance without guard or suspension chain, may cause personal
injury or lead to damage to the tractor and/or the machine.
 Use universal drive shafts approved by the manufacturer only.
 Follow the directions in the operator’s manual of the universal
drive shaft manufacturer.
2. Unscrew the ring eyelet [1]
and screw [2] of the protec-
tive plate on the universal
drive shaft bracket with the
adjustment lever.
For the position of the adjust-
ment lever, see
Figure 6.15 .
3. Set down the protective
plate.
Figure 6.1: Removing the protective plate
1
2