Rauch Axent Isobus, Инструкция по эксплуатации

Страница: 69 / 74

Alarm messages and possible causes
63
6
6 Alarm messages and possible causes
Various alarm messages can be displayed on the AXENT ISOBUS machine con-
trol unit display.
6.1 Meaning of the alarm messages
Message in display Possible cause/action
Error at left pre-metering slider cylin-
der The position at the left pre-metering slide could not be
reached

Blockage

Hydraulic cylinder defective
Error at right pre-metering slider cylin-
der The position at the right pre-metering slide could not be
reached

Blockage

Hydraulic cylinder defective
AXENT empty The hopper is empty.
Function-Stop All connected devices are in a safe condition.
The stop switch was operated.
Spreader overloaded! The machine is overloaded

The load inside the machine exceeds 10,000 kg
Manual mode active. Risk of fertiliser
overflow. The message is displayed on switching over from auto-
matic to manual.
Cover open! Switch is not operated, the loading function is not possi-
ble.
The rear cover is open and not properly closed.
Stop loading! The message is displayed on switching over to the sys-
tem/test menu during operation.
1. Stop spreading operation.
2. Open the system/test menu.
Low oil level! Insufficient oil level in the hydraulic circuit.

Stop the machine and refill oil.
Cannot be selected! The operating mode set in the AXIS H ISOBUS machine
control unit does not comply with the settings of the AX-
ENT ISOBUS machine control unit.

Set the correct operating mode. See : Operating
mode selection, page 35
Belt speed not reached The conveyor belt has not reached the target speed
within 5 s.