Rauch AERO ISOBUS, Дополнительные инструкции

Страница: 60 / 66

6 Alarm messages and possible causes
6.1 Meaning of the alarm messages
Various alarm messages can be displayed on the ISOBUS terminal display.
No. Message in display Meaning and possible cause
4 Hopper left empty! The filling level sensor on the left reports
“empty.”
• The left hopper is empty.
5 Hopper right empty! The filling level sensor on the right reports
“empty.”
• The right hopper is empty.
32 Externally controlled parts can be moved.Risk
of injury through squeezing and shearing! -
Direct ALL persons out of the danger zone -
Read the instruction manual Confirm with
ENTER If the machine control unit is activated,
components may move unexpectedly.
• Follow the displayed instructions only if all
risks have been eliminated.
81 Low oil level! Insufficient oil level in the hydraulic circuit.
• Stop the machine and refill oil.
83 Reduce oil temp. The oil temperature of the blower drive has
reached the alarm limit that has been set and
the radiator does not start.
• Does the radiator have power?
• Check the power supply and plug
connections and replace them, if
necessary.
97 Set metering RPM not reached at Section(s)
• Blockage
• Target speed too high. Enter a value
lower than 120 rpm.
• Not enough oil in the oil reservoir
• Oil too cold
109 Forward speed or application rate too low Minimum application rate alarm that has been
set has been reached.
or
Minimum speed that has been set has been
reached.
6. Alarm messages and possible causes
60
5903001 AERO ISOBUS