9
３
10
BATTERY REPLACEMENT
NOTES
1.Notes to battery replacement
The seat cover is disassembled. The
male connector and female connector
are pulled out and then two-end wires
are untied in the positive and negative
electrodes of the battery. The screw
driver is applied to remove screw (M4X
12 screw) of the battery casting
component. After that, the battery
casting component (3) is taken and
then battery is taken for replacement
(as shown in the figure 9).
The battery with the same or equivalent type as or with the recommended
can be used.
The adult shall monitor the replacement of the battery.
The battery shall be placed according to the correct polarity and the short
circuit of the power supply terminal shall be avoided.
In case of long-term non-use, please take out the battery to avoid leakage
and corrosion; when the battery is lacking of electricity, it shall be taken
out of the car body.
The battery is equipped with self-
recovery fuse (over-current protector).
In case of any overload and improper
use, when the motor is closed, the
fuse will automatically disconnect
power for about 10 - 20 seconds, and
close key switch. After removing fault
and waiting for 10 seconds, the fuse
will make self-recovery.
Over-current
protector
The over-current protector is installed under the seat tail and can be seen
after the seat is taken when turning the skewed slot in the tail position.
Battery casting
component screw
Male
connector
Female
connector
