17
1.
After putting through the power, press "ON/OFF" button on remote controller to
turn on the air conditioner.
（
Only applicable to heat pump model
）
2.
Press "MODE" button to select your required mode: AUTO, COOL, DRY, FAN,
HEAT
3.
Press "▲" or " " button to set your required temperature. (T
emperature can not
be adjusted under auto mode).
4.
Press "FAN" button to set your required fan speed: auto, low speed, low-medium
speed,medium speed, medium-high speed,high speed.
Operation guide
▲
Replacement of batteries in remote controller
1. Press the back side of remote controller marked
with " ", as shown in the
fi
g, and then push out
the cover of battery box along the arrow direction.
2. Replace two 7# (AA
A 1.5V) dry batteries, and
make sure the position of "+" polar and "-" polar
are correct.
3. Reinstall the cover of battery box.
signal sender
battery
Cover of battery box
remove
reinstall
● During operation, point the remote co
ntrol signal sender at the receiving
window on indoor unit.
●
The distance between signal sender and receiving window should be no
more than 8m, and there should be no obstacles between them.
● Signal may be interfered easily in the
room where there is fluorescent lamp
or wireless telephone; remote controller should be close to indoor unit during
operation.
● Replace new batteries of the same model when replacement is required.
● When you do not use remote controller for a long time, please take out the
batteries.
● If the display on remote controller is fuzzy or there is
no display, please
replace batteries.
NOTICE
5.
Press " " button to select fan blowing angle.
