●
The ventilation function is not applicable to this model.
no display
●
●
●
Outdoor temperature display is not available for specific models. At that time, indoor
unit receives " " signal, while it displays indoor set temperature.
It’s defaulted to display set temperature when turning on the unit.There is no
display in the remote controller.
Only for the models whose indoor unit has dual-8 display.
When selecting displaying of indoor or outdoor ambient temperature, indoor
temperature indicator displays corresponding temperature and automatically turn
to display set temperature after three or five seconds.
●
●
Under energy-saving function, fan speed is defaulted at auto speed and it can’t
be adjusted.
15
Function introduction for combination buttons
LCD displays " ". Press the button for the second time to start air purification
and ventilation functions simultaneously; LCD displays " " and " " . Press this
button for the third time to quit air purification and ventilation functions simultaneously.
Press the button for the fourth time to start air purification function; LCD display " " .
Press this button again to repeat the operation above.
16
TEMP button
By pressing this button, you can see indoor set temperature, indoor ambient temp-
erature or outdoor ambient temperature on indoor unit’s display. The setting on
remote controller is selected circularly as below:
When selecting " " or no display with remote controller, temperature indicator
on indoor unit displays set temperature.
When selecting " " with remote controller, temperature indicator on indoor unit
displays indoor ambient temperature.
When selecting " " with remote controller, temperature indicator on indoor unit
displays outdoor ambient temperature.
Energy-saving function
Under cooling mode, press "TEMP" and "CLOCK" buttons simultaneously to
start up or turn off energy-saving function. When energy-saving function is started
up, "SE" will be shown on remote controller, and air conditioner will adjust the set
temperature automatically according to ex-factory setting to reach to the best
energy-saving effect. Press "TEMP" and "CLOCK" buttons simultaneously again to
exit energy-saving function.
Note:
Note:
●
●
●
