12
Introduction for buttons on remote controller
I FEEL button
9
Press this button to start I FEEL function and " " will be displayed on the remote
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close I FEEL function and " " will disappear.
●
Please put the remote controller near user when this function is set. Do not put
main unit setting temperature will increase 1
, after two hours, setting temperature increa-
sed 2
, then the unit will run at this setting temperature. In Heat mode: sleep status
after run for one hour, the setting temperature will decrease 1
, after two hours, setting
temperature will decrease 2
, then the unit will run at this setting temperature.
●
Sleep 2 ( ) is sleep mode 2, air conditioner will run according to the presetted
group of sleep temperature curve.
●
Sleep 3( )the sleep curve setting under “Sleep mode by DIY”;
(1)Under Sleep 3 ( )mode, press “Turbo” button for a long time, remote controller enters
into user individuation sleep setting status, at this time, the time of remote controller
will display “1hour”, the setting temperature “88” will display the corresponding temp-
erature of last setting sleep curve and blink (The first entering will display according to
the initial curve setting value of original factory);
(2)Adjust
"▲"
and " " button, could change the corresponding setting temperature,
after adjusted, press “Turbo” button for confirmation;
(3) At this time, 1hour will be automatically increased at the timer position on the remote
control, (that are "2hours" or "3hours" or "8hours"), the place of setting temperature "88"
will display the corresponding temperature of last setting sleep curve and blink;
(4) Repeat the above step (2)~(3) operation, until 8 hours temperature setting finished,
sleep,curve setting finished, at this time, the remote controller will resume the original
timer display; temperature display will resume to original setting temperature.
●
Sleep3( ) the sleep curve setting under “Sleep mode by DIY” could be inquired:
The user could accord to sleep curve setting method to inquire the presetting sleep
curve,
enter into user individuation sleep setting status, but do not change the tempera-
ture, press “Turbo” button directly for confirmation.
Note: In the above presetting or enquiry procedure, if there is no button passed within
10s, the sleep curve setting status will be automatically quit and resume to display the
original displaying. In the presetting or enquiry procedure, press "ON/OFF" button,
"Mode" button, "Timer" button or "Sleep" button, the sleep curve setting or enquiry
status will quit correspondingly.
SLEEP button
8
●
Press this button, can select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and cancel
the Sleep function, circulate between these. After electrified, Sleep Cancel is defaulted.
Sleep 1( )is Sleep mode 1, in Cool mode; sleep status after run for one hour, the
▲
