Rasilient PixelStor 5000, Руководство пользователя

Страница: 41 / 161

Hardware Installation
PixelStor 5000 User Manual
Rev. 1, May 2013 3-4
Each pair of Brackets is supplied with a set of screws: 10-32, 12-24, M6. Use the size
appropriate for your Rack. For those Racks with square holes use the included flanged nuts
to secure the screws. Note the pair of screws that are attached to the chassis. Use these
screws to secure the chassis into the Rack.
Lift the system to the desired position on the rack with the help of a second person.
Tighten the screws to fix the chassis to the rack.
3.3
Installing Hardware Modules
3.3.1
Controller Modules
This PixelStor 5000 is designed to operate with one or two controller modules. When the
PixelStor 5000 is equipped with dual controller modules, the hot-swappable redundant function
is enabled. If one controller module fails, the surviving controller takes over all storage volumes
and host connections. With redundant controllers, you can replace the failed controller module
without powering off the PixelStor 5000, because the surviving controller module takes the
place of the failed one.
The location of the controller modules on the chassis is shown below:
Make sure the Brackets are installed at the level where you wish to install your
PixelStor 5000 system.
For best results, start installing systems from the bottom of the rack and move up.