Raritan PXE, Руководство пользователя

Страница: 148 / 382

Chapter 6: Using the Web Interface
132
To select all methods, simply click .
c. To delete any method, select it in the left list box, and click to
move it back to the right list box. To make multiple selections,
press Ctrl+click or Shift+click to highlight multiple ones.
To remove all methods, simply click .
7. In the Available Sensors field, select the desired sensor.
a. Select the sensor type from the field to the left.
b. Select the specific sensor from the field to the right.
c. Click the Add button to add the selected sensor to the
Report Sensors list box.
For example, to monitor the current reading of the Inlet 1, select Inlet
1 from the left field, and then select RMS Current from the right field.
8. To report additional sensors simultaneously, repeat the above step
to add more sensors.
 To remove any sensor from the Report Sensors list box, select it
and click the Delete button . To make multiple selections,
press Ctrl+click or Shift+click to highlight multiple ones.
9. To immediately send out the sensor report, click Send Report Now.
A message appears, indicating whether the sensor report is sent
successfully.
10. To save this action, click OK.
Note: When intending to send a sensor report using custom messages,
use the placeholder [SENSORREPORT] to report sensor readings. See
Email and SMS Message Placeholders (on page 144).
Switch Peripheral Actuator
If you have any actuator connected to the PXE, you can set up the PXE
so it automatically turns on or off the system controlled by this actuator
when a specific event occurs.
Note: For information on connecting actuators to the PXE, see DX
Sensor Packages (on page 25).
To switch on or off the system connected to an actuator:
1. Click the Actions tab.
2. Click New.
3. In the "Action name" field, type a new name for the action. The
default name is New Action <number>, where <number> is a
sequential number starting at 1.