Raritan PX3TS, Руководство пользователя

Страница: 42 / 842

Chapter 3: Initial Installation and Configuration
18
Dual Ethernet Connection (for iX7™ Only)
An iX7
™
device has two Ethernet (LAN) ports:

ETH 10/100/1000 (marked in
green) supports up to 1000 Mbps. This
is "ETH1".

ETH 10/100 (marked in white) supports up to 100 Mbps. This is
"ETH2".
For more information on the two ports, see Connection Port Functions
(on page 95).
You can connect both ports to
different subnets (networks) and therefore
obtain two IP addresses for wired networking. It is strongly
recommended that you DO NOT connect both ports to the same subnet to
avoid potential issues. Contact your IT department if you are not sure
whether the two Ethernet ports are connecting to the same or different
subnets.
Exception: A USB-cascading chain must connect to "only one" network.
Do NOT connect both Ethernet ports of an iX7
™
master or slave device to
the LAN. See Cascading Multiple PX3TS Devices for Sharing Ethernet
Connectivity (on page 28).
Check list when connecting both ports to the networks:

Both Ethernet interfaces are connecting to different subnets.

Both Ethernet interfaces have been enabled. By default both are
enabled. See
Device Info (on page 126) and Ethernet Interface
Settings (on page 272).

Both Ethernet interfaces are configured with proper IPv4 and/or IPv6
settings. See
Wired Network Settings
(on page 270).

It is NOT required that the two Ethernet interfaces share similar
network settings. For example, you can enable IPv4 settings in
one interface but enable IPv6 settings in the other, or apply
static IP to one but DHCP IP to the other.

The cascading mode is disabled. By default it is disabled. See
Setting
the Cascading Mode
(on page 282).