Raritan PX3-3000 series, Руководство пользователя, Страница: 648 / 875

Chapter 8: Using the Command Line Interface
624
Switching On an Actuator
This command syntax turns on one actuator.
# control actuator <n> on
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
# control actuator <n> on /y
Variables:

<n> is an actuator's ID number.
The ID number is available in the PX3 web interface or using the
show command in the CLI. It is an integer between 1 and 32.
If you entered the command without "/y", a message appears, prompting
you to confirm the operation. Then:

Type
y
to confirm the operation, OR

Type
n
to abort the operation
Switching Off an Actuator
This command syntax turns off one actuator.
# control actuator <n> off
To quicken the operation, you can add the parameter "/y" to the end of
the command, which confirms the operation.
# control actuator <n> off /y
Variables:

<n> is an actuator's ID number.
The ID number is available in the PX3 web interface or using the
show command in the CLI. It is an integer between 1 and 32.