Raritan EMX2-111, Руководство пользователя

Страница: 340 / 565

Chapter 8: Using the Command Line Interface
328
config:# network ipv4 staticRoutes modify <route_ID> <dest-2> interface <ETH>
Variables:

<dest-1> is a combination of the IP address and subnet mask of the
other subnet. The format is
IP address/subnet mask.

<hop> is the IP address of the next hop router.

<ETH> is one of the interfaces: ethernet, wireless and bridge. Type
"bridge" only when your EMX is in the bridging mode.

<route_ID> is the ID number of the route setting which you want to
delete or modify.

<dest-2> is a modified route setting that will replace the original
route setting. Its format is
IP address/subnet mask. You can modify
either the IP address or the subnet mask or both.
Configuring IPv6 Parameters
An IPv6 configuration command begins with
network ipv6.
Setting the IPv6 Configuration Mode
This command determines the IP configuration mode.
config:# network ipv6 interface <ETH> configMethod <mode>
Variables:

<ETH> is one of the network interfaces:
ethernet, wireless, bridge or
all. Note that you must choose/configure the bridge interface if your
EMX is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE
interface function. The IP parameters of the ETHERNET and
WIRELESS interfaces do NOT function.
Interface Description
ethernet Determine the IPv6 configuration mode of the
ETHERNET interface (that is, wired networking).
wireless Determine the IPv6 configuration mode of the
WIRELESS interface (that is, wireless
networking).
bridge Determine the IPv6 configuration mode of the
BRIDGE interface (that is, bridging mode).