Chapter 6: Using the Web Interface
135
Schneider Electric PowerLogic PM710
All settings are configured on a per port basis. If you disconnect a PM710
from one EMX port and connect it to another EMX port, you must
reconfigure the settings. However, if you disconnect a PM710 from an
EMX port and then plug it back into the same port, the
already-configured settings still apply.
The PM710 saves readings when they reach their highest and lowest
value. The highest value and lowest value are the minimum and
maximum values, which can be reset as needed. Besides, it also saves
energy accumulator values, which can be also reset. Refer to your
PM710 documentation for additional information.
PM710 information shown:
The following PM710-related information is shown on this page.
PM710-related device data, including device type and operational
state.
All sensor readings and power quality values gathered by PM710.
For some readings followed by the symbol "^", such as
, you need to click it to view its details.
To configure the PM710:
1.
On the PowerLogic PM710 page, click Edit Settings.
2.
Enter a name for the sensor.
3.
Leave the device address, line speed and parity as is so it matches
the PM710 settings.
4.
Click Save.
Содержание EMX2-111
