SE BRUKSANVISNING
15
PRODUKTDIAGRAM
Säkra strömsladden till ljusslingan genom att dra åt den gängade kragen.
Obs! /- kablar vid anslutning.
Använd endast RAPTOR-ljusslingans förlängningssladdar och kontakter.
Avsluta monteringen med en ändkåpa på den sista anslutningsnoden.
KLÄMMER TILL LED-SLINGA
PRODUCT DIAGRAM:
Secure RAPTOR power cord to Rope Light by tightening threaded collar.
NB! Note +/- leads when connecting.
Only use RAPTOR Rope Light extension cords and connectors.
Finish assembly with an end cap on the last connector-node.
MOUNTING INSTRUCTION:
Secure Rope Light with Rope Light clamps (for temporary installation, nylon strips can be
used).
Minimum bending diameter is 8cm. Do not fold the LED strip during installation
RAPTOR Rope Light can be used indoor and outdoor (IP65). Do not submerge in water.
Installing in cold areas (below 5°C):
Risk of cracking / breakage! Unpack and unroll the Rope Light and connect to power-supply.
After 10-15 minutes the product will be warm enough to bend easily or be straightened out.
Disconnect from power supply before installing.
Storage:
Store in a dry and well-ventilated environment.
Repacking in cold areas (below 5°C):
Risk of cracking / breakage! Detach the Rope Light and connect to power-supply. After 10-15
minutes the product will be warm enough to bend easily and be repacked. Disconnect from
power supply before repacking.
Säkra den anslutna strömsladden
genom att dra åt den gängade
kragen till LED-ljusslingan före
installation.
Kontakt
Strömsladd
Omvandlare
LED-remsa
Ändkåpa
Step 1: Tear Back Side Red 3M tape of
Stainless Steel and Mounted
with Nail Plug
Step 2: Fix the Stainless Steel on The
Wallby Screws through the
Fixing Hole
Step 3: Push the Strip into Stainless
Steel Clip
and Fix Stable
