Rapid 2005, Инструкция по установке, эксплуатации и обслуживанию

Страница: 36 / 162

B-S
ERIES
I
NSTALLATION
, O
PERATION AND
S
ERVICE
M
ANUAL
26 of 147
SECTION 10: INDOOR SUSPENSION MOUNTING - HORIZONTAL AIR HANDLER
S u spension Kits are a v ailable for models 2005 -
2010B. Kits are shipped u nassembled and m u st be
assembled prior to installation. S u spension Kits for
models 2020 - 2030 are not a v ailable.
NOTE: Before installation, v erify all req u ired
components are present. If any are missing, contact
yo
u r RAPID ® independent distrib u tor.
10.1 Suspension Kit Assembly and Installation
After the air handler is in place, the installer m u st
fasten the air handler to the s u spension frame. Once
the s u spension frame is sec u re, the air handler may
be mo u nted. See Page 17, Section 6 for safe lifting
practices.
On model 2005, remo v e the 1/4" bolts from fo u r
corners of base on length of air handler. Slide
s
u spension angle assembly onto both ends of the air
handler aligning holes in angle tab w ith bottom holes.
Once completed, reinstall hard w are. See Page 27,
Figure 20 .
On model 2010 and 2010B, drilling holes do w n
thro u gh the floor of the air handler and into the
s u spension frame. At least three #12 sheet metal
scre w s (s u pplied by others) eq u ally spaced on each
angle/side m u st be u sed to attach the air handler to
the s u spension frame. See Page 28, Figure 21 .
Crush Hazard
Check blower assembly per
maintenance section.
Lack of blower assembly
maintenance can cause
excessive vibration.
Excessive vibration can
cause support failure.
WARNING
Failure to follow these instructions can result in death, injury or property damage.
Crush Hazard
Hanging hardware must
support equipment weight.
Do not hang by lifting lugs.
Crush Hazard
Use proper lifting equip-
ment and practices.
WARNING
Failure to follow these instructions can result in death, injury or property damage.
Falling Hazard
Use proper safety
equipment and practices to
avoid falling.
Severe Injury Hazard
Use proper lifting practices
and equipment.
Equipment and accessories
are heavy.
Cut/Pinch Hazard
Wear protective gear during
installation, operation and
service.
Edges are sharp.