Operating Instructions RS cure
│
D cure
│
P cure
│
SHERAprint cure
│
3Decure
Rapid Shape GmbH
│
DOCR000251
16
│
27
3.
Remove all transport locks from the machine.
4.
Make sure that the four feet of the machine are completely
resting on the ground.
4.3
Connecting
4.3.1
Power Connection
To make the power connection, please proceed as follows:
1.
Prerequisite: The machine has already been set up.
→
Chapter 4.2.2
2.
Slide the cap of the power plug back until the stop and hold the
cap in this position. Then insert the plug into the power
connection of the machine.
Pay attention to the positioning of the plug. The flat plug side
must point inwards!
3.
Then, connect the power supply to the nearest outlet. Be careful
not to trip over cables lying around.
4.
Recommended: Connect a network cable to the Ethernet port on
your machine and to your network interface. In this way,
software updates can be installed automatically.
5.
Then switch on the machine.
→
Chapter 6.2
4.3.2
Connect Protective Gas
To make the protective gas supply, please proceed as follows:
1.
Connect the hose from the protective gas supply to the gas
connection on the back of the machine
2.
Check that the specified inlet pressure is maintained.
→
Chapter 10
4.3.3
Connect to Other Machines
The post curing unit can be connected to existing 3D printers in the
surroundings. In this way, completed print jobs are sent from the 3D
printer to the post curing unit and allow a curing process based on the
print job submitted.
To establish a connection between the post curing unit and the 3D
printer, please use the ‚Settings’ menu item
→
‚Set up connection with
printer’.
