Rankam Member's Mark GR2298901-MM-02, Инструкции по сборке и эксплуатации

Страница: 22 / 31

22 of 31 20190827-Ver.1.0
LEAK TEST
GENERAL
Although all gas connections on the grill are leak tested at the factory prior to shipment, a
complete gas tightness check must be performed after assembly to ensure fittings were not
damaged after leaving the factory. Periodically check the entire system for leaks following the
procedures listed below.
BEFORE TESTING
Make sure that all packing material is removed from the grill including tie-down straps. Make a
soap solution of one part liquid detergent and one part water. You will need a spray bottle, brush,
or rag to apply the solution to the fittings. For the initial leak test, make sure the LP cylinder is full.
WARNING
 NEVER PERFORM LEAK TEST WITH AN OPEN FLAME OR WHILE SMOKING.
 If there is excessive abrasion, wear, or damage to the hose, parts must replaced prior
to operation. The replacement hose must be specified by the manufacturer.
TO TEST
1. Make sure the control valves are in the OFF position
then turn on the gas supply.
2. Check all connections from the gas cylinder, LP gas
regulator, and supply valve, including all connections to
the pipe for the burners.
Points where the soap-water mixture should be applied
(soap bubbles will appear if a leak is present):
A Supply tank (cylinder) weld.
B Connection nut to tank valve.
C Back side of connection nut to brass nipple.
D Brass nipple connections to gas supply hoses.
E Regulator connections to gas supply hose.
F Tank valve to cylinder
G Hose connection to gas manifold.
H The full length of gas supply hose.
3. If a leak is present, immediately turn off the gas supply and tighten the leaky fittings.
4. Turn the gas back on and recheck.
5. Should gas continue to leak from any of the fittings, turn off the gas supply and contact
customer service department at 1-888-837-1380, 8 a.m. - 5 p.m., Pacific Standard Time, Monday
- Friday.