Ranger R76ATR, Инструкция по установке и эксплуатации

Страница: 22 / 88

R76 Series of Tire Changers
22
P/N 5900346 — Rev. C — Dec. 2019
Test the Tire Changer
Make sure the following items have been done before putting the Tire Changer into normal operation:
• Check for pneumatic (air) pressure . The Tire Changer requires pneumatic energy to
perform certain functions.
To see if the Tire Changer has air pressure, take the Air Chuck and lightly step on and hold down
the Inflation Foot Pedal. If air comes out, the Air Source is connected and working.
•
Test the power source
. Other Tire Changer functions require electric power. Step on and hold
down the Turntable Foot Pedal to check for electric power. If the Turntable turns, you have power.
• Make sure there is Tire Lubricant available . Your shop probably has a brand of Lube that
it prefers. Make sure some is in the Lube Bucket on the Tire Changer. Always use Lube; it makes
changing Tires easier and helps prevent damage to the Tire and the Wheel.
•
Test the Tool Arms on the Assist Tower (R76ATR only)
. Manually move each Tool Arm
separately from side to side. Use the Assist Tower Controls to raise and lower the Tool Arms (they
move up and down together). If the Tool Arms can do these things, they are working correctly.
• Change some non-customer Tires . To get used to the Tire Changer, BendPak Ranger
strongly recommends that all potential Operators change multiple
non-customer Tires of different
types
before letting them change customer tires.
Final Checklist Before Operation
Do the following things before putting your Tire Changer into normal operation:
• Review the Installation Checklist to make sure all steps have been performed.
• Make sure the Tire Changer is getting electric and pneumatic power.
• Check to see that all Anchor Bolts are in position and tightened, if you installed them.
• Make sure the Tire Changer has been used to change some non-customer Tires.
• Leave the Manual with the owner/operator.