P
hono Pull Unit –
M
ulti Use
Order code: PPMU
3.0 INSTALLATION:
Items
necessary:
Multi-Use Phono Pull unit (PPMU)
Power (220-240VAC) for external power supply (PS included)
5 Microphones MIC00 with pedestals/tripods MIC03 (not included)
Microphone cables of any type with 2 wires (approx 0,5mm² each)
and cable connecting PPMU to trap (not included)
1..5 microphone connectors (included)
Plug for connecting cable to trap (included)
Soldering iron & solder (not included)
Small screwdriver (not included)
Step1
:
Cut microphone cables and trap release cable to appropriate length
Please note: All microphone cables have to be of the same length and diameter of wires!
Step2
:
Solder microphone cable with microphone connectors
Step3
:
Connect microphone cables with the microphones
Please note: Connecting less then 5 microphones will make the Phono pull “hyper-sensitive”
and “false positives” might occur due to ambient noise!
ALWAYS CONNECT ALL 5 MICROPHONES!
Also be aware, that minimum distance between adjacent microphones must be > 1,5m!
Step4
:
Connect trap release cable to trap:
Pin out on 4 ways plug:
Pin1: +12V, Pin2: Relays in, Pin3: Relays out, Pin4: Ground (-)
Check if you need power supplied with ground(minus) switched
or if you operate your trap in a push button style.
+12V and switched ground: C to pin 1 on connector, then connect –
to pin 2 on connector, make a bridge between pin 4 and pin 3.
Operate in push button mode:
1 wire goes to pin 2, 1 wire goes to pin 3, pin1 & pin4 are not connected
Step5
:
Ensure that all 5 microphones are properly connected to the 5 corresponding connectors B5
Connect Power supply with PPMU and to external AC power
Using another power supply (e.g. car battery): ensure that voltage is above 12V and
below 15V. As there is a rectifier inside PPMU, you do not have to care about polarity!
R
ANGEMASTER
S
YSTEMS-Maxima WarenhandelsGmbH
Web: www.rangemaster.at
Phone:+43 699 10403204
Rev.date:02/03/21 Page:
4
8010 Graz, Dr. Robert Graf Straße 64/9, Austria/Europe
Mail: [email protected]
Fax:+43 720 920 195
Doc name: PPMU_ENG.doc