Rane SEVENTY, Руководство пользователя

Страница: 15 / 84

15
Custom Pad Sets
Seventy comes with two customizable pad modes. For these modes, you can use Serato DJ Pro’s MIDI
mapping feature to program the
Performance Pads to trigger functions of your choosing.
To enter a custom pad mode, press either Roll or Transport so that the button lights white (with all the
other Pad Mode buttons lit red ).
To create a custom pad set:
1. While connected to Serato DJ Pro, make sure that Seventy is entered into one of the two custom pad
modes (as described above).
2. In Serato DJ Pro, open the Setup menu and select MIDI .
3. Select Seventy and make sure that Allow Serato DJ Hardware Remapping is enabled. Close the
Setup window.
4. In the main Serato DJ Pro window, click the MIDI button at the top of the screen to begin mapping.
5. Click a feature in Serato DJ Pro, then touch or move a control on your hardware to map the feature to
that control.
See the Serato DJ Pro manual for more information on MIDI mapping.
Settings Menu
The Seventy comes with various settings that you can edit and save in order to customize the mixer’s
operation. Settings can be edited in the Settings Menu, which can be viewed on the
Display .
Navigating the Settings Menu
To enter or exit the Settings Menu on the Display , hold Shift

and press the Tap button .
To highlight pages or settings in the menu , push the FX Joystick up and down.
To select pages in the menu , press the Parameter Knob .
To go back one page in the menu, push the FX Joystick to the left.
To edit settings in one of the menu pages , turn the Parameter Knob while the setting is highlighted.
To save your changes to a setting , press the Parameter Knob while the setting is highlighted.
Menu Options
The Settings Menu contains the following pages and options:
Mixer Settings: Select this page to adjust settings for some of the mixer’s audio controls.
•
Audio Out: Select this option to edit the Main Out and Mix Pan settings.
•
Deck 1 Settings and Deck 2 Settings: Select these options to edit the Phono 1 / 2 Sensitivity , EQ
XOver 1 / 2, and Deck 1 / 2 Pan settings.
Note: Set Phono Sensitivity to the settings recommended by your cartridge's manufacturer.
•
Filter Setup: Select this option to edit the Deck 1 / 2 Resonance , the cutoff frequency for the LOW
position of the filter knobs ( Low Pass Min ), or the cutoff frequency for the HI position of the filter knobs
( High Pass Max ).
•
Pad Setup: Select this option to edit the Pad Sensitivity settings.
•
HP (Headphone) Setup: Select this option to edit the headphone Tone setting.