9
REAR PANEL:
MONO 4-WAY AND MONO 5-WAY CONNECTIONS
Observe the labels
below
the Inputs and Outputs for Mono operation.
1.
Mono Input:
Connect the output from your mixer or other signal source only to the Mono 4W / 5W input for
Mono operation; do not use the Channel 2 input. Pin 2 is “hot” per AES standards.
2.
Subwoofer Output:
Connect the Sub Out to the input of the subwoofer (or bass bin) amplifier.
3.
Low Output:
Connect the Low Out to the input of the low frequency (mid-bass) amp.
4.
Mid Output:
Connect the Mid Out to the input of the mid frequency amplifier.
5.
High-Mid Output (for mono 5-way only):
Use this output only for Mono 5W applications. Connect the High-
Mid Out to the input of the high-mid frequency amplifier.
Do not use this output when using the AC 23S as a
Mono
4W Crossover. In 4W
,
the AC 23S internally bypasses the High-Mid section and defeats all front panel
High-Mid controls.
6.
High Output:
Connect the High Out to the input of the high frequency (tweeter) amp.
7.
Stereo / Mono Switch:
Push this to the Mono (
in
) position.
8.
Stereo 2-Way / 3-Way Switches:
For Mono 4W or 5W, slide these switches to the 3W position.
9.
Mono 4-Way / 5-Way Switch:
In 4W, the High-Mid output duplicates the Mid output frequencies with a
different low pass setting as determined by the High-Mid / High frequency control, and is not normally
recommended for use since the tweeter crossover point will be inaccurate.
10.
Power Input:
Connect the included power cable here. Do
not
lift the ground connection!
If your 4-way system needs a higher range of 190 Hz-7 kHz for Low / Mid, see the configuration on the
following page.
10
10
6 5 3
8
7
9
8
4 2 1
Содержание AC 23S
