Network and remote settings
R&S
®
ZNL/ZNLE
156
User Manual 1178.5966.02 ─ 19
Computer Name
Each instrument is delivered with an assigned computer name, but this name can be
changed. The naming conventions of Windows apply. If too many characters and/or
numbers are entered, an error message is displayed in the status line.
The default instrument name is a non-case-sensitive string with the following syntax:
<Type><variant>-<serial_number>
For example
FPL1003-123456
The serial number can be found on the rear panel of the instrument. It is the third part
of the device ID printed on the bar code sticker:
IP Address
Defines the IP address. The TCP/IP protocol is preinstalled with the IP address
10.0.0.10. If the DHCP server is available ("DHCP On"), the setting is read-only.
The IP address consists of four number blocks separated by dots. Each block contains
3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address).
Subnet Mask
Defines the subnet mask. The TCP/IP protocol is preinstalled with the subnet mask
255.255.255.0. If the DHCP server is available ("DHCP On"), this setting is read-only.
The subnet mask consists of four number blocks separated by dots. Each block con-
tains 3 numbers in maximum (e.g. 100.100.100.100), but also one or two numbers are
allowed in a block (as an example see the preinstalled address).
DHCP
Switches between DHCP server available (On) or not available (Off). If a DHCP server
is available in the network, the IP address and subnet mask of the instrument are
obtained automatically from the DHCP server.
Network Configuration
Opens the standard Windows "Network Configuration" dialog box for further configura-
tion.
8.4.2
Remote settings
Access
: [Setup] > "N Remote" > "Remote" tab
GPIB-specific settings are only available if option R&S
FPL1-B10 is installed on the
R&S
ZNL/ZNLE.
Network and remote control settings
