Working with the Measurement Wizard
R&S
®
ZNH
97
User Manual 1334.5985.02 ─ 02
Figure 6-2: Measurement setting dialog
Table 6-1: Measurement setting parameters
Measurement parameters
Descriptions
"General"
User
Name of the person that performs the measurement.
Measurement
Definition
Name of the measurement wizard set. This field is a read-
only field that shows the measurement name as defined in
the R&S InstrumentView software package.
Number of
Steps to Per-
form
Number of individual measurements in the measurement
sequence as defined with the R&S InstrumentView soft-
ware package.
The field allows you to reduce the number of individual
measurements and perform only those measurements that
are necessary. If you reduce the number of measurements,
the R&S
ZNH omits the last measurement in the sequence.
You can edit this field only if you turned on the "Allow Vari-
able Number of Sequence Steps" in the "Wizard Set Editor"
of the R&S InstrumentView software.
Descriptions
Short description of the measurement task. This field is a
read-only field that shows the description as defined with
the R&S InstrumentView software.
"Site"
Site Name
Location of the measurement.
Performing and Configuring Measurements
