R&S VTE, Начало работы

Страница: 33 / 52

Instrument Tour
R&S
®
VTE
33 Getting Started 2116.1270.02 ─ 07
5.2.5 REF OUT
See (5) in Figure 5-2 .
BNC connector. Output of the internal reference signal. If activated, a signal is
always present at this output.
When using an internal reference, the frequency generated by the internal refer-
ence oscillator of the R&S
VTE is made available. If an external reference is acti-
vated, the signal applied to the reference frequency input is also available here. It
is buffered and filtered.
See the user manual or the help system.
5.2.6 DISPLAY PORT
See (6) in Figure 5-2 .
The display port connector provides the monitor output signal of the built-in com-
puter. The connected computer monitor needs to provide a resolution of
1024x768 pixels or higher.
You can use either the DISPLAY PORT or the DVI-D port. Using both con-
nectors at the same time is not supported.
5.2.7 DVI Port
See (7) in Figure 5-2 .
DVI-D socket. Output for the monitor signal of the built-in computer. The connec-
ted computer monitor needs to provide a resolution of 1024x768 pixels or higher.
You can use either the DISPLAY PORT or the DVI-D port. Using both con-
nectors at the same time is not supported.
You can use a DVI-I cable for connecting R&S
VTE and display, but the
analog video interface (pins C1 to C4) is not provided by the R&S VTE.
Rear Panel