Manual Operation
R&S
®
UPV
219
Getting Started 1146.2078.62 ─ 09
Freq Ch1
Phase Ch2/Ch1
Freq/Phase ...
●
These combo displays are extensions to the numeric measurement display
of the frequency/phase measurement selected in the "Analyzer
Function"
panel; they show the respective numeric value plus the following additional
features
●
Analog bar graphs
●
Monitoring and display of limits
●
Storage of minimum and maximum values
●
The measurement results are displayed in the way defined in the configura-
tion panel
Sweep Graph 1 to 4
●
Up to four of these display windows can be open simultaneously to display
scans from sweep measurements
●
One-channel or two-channel graphical display
●
The measurement results are displayed in the way defined in the respective
"Sweep
Graph
1 to 4
Config" configuration panel
Impulse Response
●
This display window shows the characteristic of an impulse response
●
One-channel or two-channel graphical display
●
The measurement results are displayed in the way defined in the "Impulse
Response
Config" configuration panel
FFT Graph 1 to 2
●
Up to two of these display windows can be open simultaneously to display
the FFT analyses of the selected measurement function or of the Post FFT
●
One-channel or two-channel graphical display
●
The measurement results are displayed in the way defined in the respective
"FFT
Graph
1 to 2
Config" configuration panel
Waveform
●
This display window shows the characteristic of the measurement signal
over time
●
One-channel or two-channel graphical display
●
The measurement results are displayed in the way defined in the "Wave-
form
Config" configuration panel
PESQ/
POLQA Graph 1…2
●
Up to two of these windows can be opened simultaneously to display
PESQ/POLQA measured values
●
The measurement results are displayed in the manner defined in the
respective "PESQ/POLQA
Graph
1…2
Config "configuration panel.
Bar Graph 1 to 2
●
Up to two of these display windows can be opened to display bar graphs of
the selected measurement function
●
One-channel or two-channel graphical display
●
The measurement results are displayed in the manner defined in the
respective "Bar Graph
1 to 2
Config "configuration panel
Dig Analyzer Protocol
●
Display window for the data regarding the digital audio protocol of the
R&S
UPV-K21 option (digital audio protocol)
4.20 Overview of Status Messages
The status of the R&S
UPV is continuously displayed for the generator, analyzer,
sweep system and other instrument states at the bottom of the screen in four fields
above the four right-hand softkeys.
Status displays always appear at the same position; they are assigned to the fields
above the softkeys as shown below.
Overview of Status Messages