Product Overview
R&S
®
TSVP
22
Getting Started 1152.3943.62 ─ 07
standby mode. In addition to the functionality of a simple power switching module,
small signals can be switched in the lower MHz range with high quality.
It offers the following key features:
●
8 switching units each uses a 4 to 1 matrix (HI and LO channel), max. 2 A /
125V per relay contact
●
Power supply or load module access per unit available using the front connec-
tor X10 or using the rear I/O module TS-PRIO (max. 1A)
●
A switchable 0.022
Ω
shunt resistor per channel for current measurements
over analogue bus connections available
●
Local high power bus LPBA and LPBB available to combine the switching
units
●
Monitoring via analogue bus up to 1A possible
●
Cross talk attenuation < - 35dB at 5 MHz ("worst case")
The rear I/O module R&S TS-PRIO can be used together with the R&S TS-
PSM2.
3.3.14
R&S TS-PSM3
The High-power Switch Module R&S TS-PSM3 is intended for the R&S Com-
pactTSVP and R&S PowerTSVP test platform. The module occupies two slots.
Control of the module is via the CAN bus. The module is available in two ver-
sions:
●
It can be ordered with a connector of the Virginia Panel Corp. (VPC) on the
front of the module as R&S TS-PSM3 (variant 03, R&S no. 1519.2516.03).
The connector is connected to the individual channels of the module via termi-
nals on the switch card using a pre-assembled cable set.
●
The R&S TS-PSM3B (variant 02, R&S no. 1519.2516.02) is delivered without
VPC, the user can connect his loads or power supply units with his own
cables via apertures on the front plate of the module to the terminals of the
channels.
It offers the following key features:
●
8 high power switching channels max 30A and 30 V DC, 46 V AC peak;
High power channels having an I-V-LEM converter for current measurements
and short cut switches max 16A / channel for test purposes; access available
Test Modules
