R&S SMW200A, Начало работы, Страница: 24 / 118

Preparing for Use
R&S
®
SMW200A
24 Getting Started 1412.9220.02 ─ 21
For more information and an overview of the settings affected by the preset
and factory preset function, see section "Restoring the (Default) Instrument
Configuration" in the user manual.
User-defined instrument states can be stored and called up using the
"Setup > Save/Recall" function or the [SAVE/RCL] key.
4.1.9 Checking the Supplied Options and Licenses
The instrument can be equipped with both, hardware and firmware options. To
check whether the installed options correspond to the options indicated on the
delivery note, proceed as follows:
1. Press the [SETUP] key.
2. Select "Instrument Assembly > Hardware Config" and "Software / Options".
A list with hardware and firmware information is displayed.
3. Check the availability of the hardware options as indicated in the delivery
note.
For an overview of the available options, refer to the data sheet.
4.2 Connecting USB Devices
The USB interfaces of the R&S SMW allow you to connect USB devices, includ-
ing USB hubs directly to the instrument. Due to the large number of available
USB devices, there is almost no limit to the expansions that are possible with the
R&S
SMW.
The following list shows various USB devices that can be useful:
●
Memory stick for easy transfer of data to/from a computer (for example firm-
ware updates)
●
Keyboard or mouse to simplify the entry of data, comments, filenames, etc.
●
Power sensors of the R&S NRP families
All USB devices can be connected to or disconnected from the instrument during
operation.
Connecting USB Devices