R&S SMJ100A, Руководство по эксплуатации

Страница: 819 / 874

Remote Control Commands
R&S
®
SMJ100A
803 Operating Manual 1403.7458.32 ─ 14
Example: TEST:DIR 'SSYN',0,#H12345678
TEST:DIR? 'SSYN',0
Response:
#H12345678
7.20 TRIGger Subsystem
The
TRIGger
system contains the commands for selecting the trigger source for the
RF and LF sweep. The trigger input connectors are configured in the
SOURce:INPut
subsystem.
The trigger system of the R&S SMJ is a simplified implementation of the SCPI trigger
system. The
TRIGger
system differs from the SCPI system as follows:
●
No
INITiate
command; the instrument behaves as if
INITiate:CONTinuous
ON
were set.
●
Under
TRIGger
several sweep subsystems exist.
Other commands associated with the trigger system of the R&S SMJ can be found in
the modulation and RF signal subsystems.
TRIGger<hw>
●
Suffix
TRIGger<1|2>
is not permitted
●
TRIGger0
activates the LF output.
Table 7-3: Cross-reference between the manual and remote control
R&S name SCPI name Command under manual con-
trol
AUTO IMMediate "Auto" mode
SINGle BUS "Single" mode.
EXTernal EXTernal "Ext Single" and "Ext Step" mode.
Use command
LFO:SWEep:MODE
to select between the two sweep
modes.
EAUTo - "Ext Start/Stop" mode.
:TRIGger<hw>:FSWeep:SOURce
....................................................................................804
:TRIGger<hw>:FSWeep[:IMMediate]
................................................................................804
:TRIGger<hw>:LFFSweep
.............................................................................................. 805
:TRIGger<hw>:LFFSweep:SOURce
.................................................................................805
:TRIGger<hw>:LFFSweep:IMMediate
.............................................................................. 806
:TRIGger<hw>:PSWeep:SOURce
....................................................................................806
:TRIGger<hw>:PSWeep[:IMMediate]
................................................................................807
:TRIGger<hw>[:SWEep]:SOURce
....................................................................................807
:TRIGger<hw>[:SWEep][:IMMediate]
................................................................................808
:TRIGger<hw>[:IMMediate]
............................................................................................. 809
TRIGger Subsystem