R&S SMJ100A, Руководство по эксплуатации, Страница: 725 / 874

Remote Control Commands
R&S
®
SMJ100A
709 Operating Manual 1403.7458.32 ─ 14
Return values:
<Value> float
Range:
-100 to 100
Increment: 0.01
*RST:
0
Example: CORR:VAL?
queries the value currently used for level correction.
Response:
-3
the correction value is - 3 dB.
Usage: Query only
Manual operation: See "User Correction Value - User Correction" on page 224
[:SOURce<hw>]:CORRection:ZERoing:STATe <State>
Activates the zeroing procedure before filling the user correction data acquired y a sen-
sor.
Parameters:
<State> 0 | 1 | OFF | ON
Manual operation: See "Fill User Correction Data with Sensor" on page 230
7.16.5 SOURce:FM Subsystem
The FM subsystem contains the commands for checking the frequency modulation.
The settings for the internal modulation source (LF generator) are made in the
SOURce:LFOutput subsystem).
For information about the required options, see Chapter 5.5.11.4, "Frequency Modula-
tion (FM)" , on page 246.
[:SOURce<hw>]:FM[:DEViation]
...................................................................................... 709
[:SOURce<hw>]:FM:EXTernal:COUPling
..........................................................................710
[:SOURce<hw>]:FM:INTernal:FREQuency
....................................................................... 710
[:SOURce<hw>]:FM:MODE
.............................................................................................710
[:SOURce<hw>]:FM:SENSitivity?
.....................................................................................711
[:SOURce<hw>]:FM:SOURce
..........................................................................................711
[:SOURce<hw>]:FM:STATe
............................................................................................ 712
[:SOURce<hw>]:FM[:DEViation] <Deviation>
Sets the deviation of the frequency modulation signal in Hz. The maximum deviation
depends on the set RF frequency and the selected modulation mode (see data sheet).
SOURce Subsystem