R&S SMJ100A, Руководство по эксплуатации, Страница: 716 / 874

Remote Control Commands
R&S
®
SMJ100A
700 Operating Manual 1403.7458.32 ─ 14
Example: CORR:CSET 'D:\user\'
selects the table ucor1.
CORR:CSET:DATA:FREQ:POIN?
queries the number of frequency values in the table ucor1.
Response:
440
the table ucor1 contains 440 frequency values.
Usage: Query only
[:SOURce<hw>]:CORRection:CSET:DATA:POWer <Power>
Transfers the level data to the table selected with
[:SOURce<hw>]:CORRection:
CSET[:SELect]
.
*RST
does not affect data lists. The numerical suffix at
SOURce
must not be used for
this command.
Parameters:
<Power> Power#1[, Power#2, ...]
Example: CORR:CSET 'D:\user\ucor1'
selects the table
ucor1
.
CORR:CSET:DATA:POW 1dB, 0.8dB, 0.75dB,...
enters the level values in the table
ucor1
.
Manual operation: See "Edit User Cor. Data - User Correction" on page 224
[:SOURce<hw>]:CORRection:CSET:DATA:POWer:POINts?
Queries the number of level values in the selected table.
The numerical suffix at
SOURce
must not be used for this command.
Return values:
<Points> integer
Range:
0 to 10000
*RST: 0
Example: CORR:CSET 'D:\user\ucor1'
selects the table ucor1.
CORR:CSET:DATA:POW:POIN?
queries the number of level values in the table ucor1.
Response:
440
the table ucor1 contains 440 level values.
Usage: Query only
[:SOURce<hw>]:CORRection:CSET:DATA:POWer:MLEVel<ch>?
Quieries the measurement results of a multi channel measurement. The values of each
column of the user correction list are queried separately, i.e. the correction values for a
specific attenuator setting.
SOURce Subsystem