R&S SMJ100A, Руководство по эксплуатации, Страница: 697 / 874

Remote Control Commands
R&S
®
SMJ100A
681 Operating Manual 1403.7458.32 ─ 14
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:POWer[:STARt] <Start>
Sets the power for the individual carriers in the defined carrier range. If the com-
mand
:BB:MCCW:EDIT:CARR:POW:STEP
is used to define a step width, the power
entered here applies only to the starting carrier. The power of the remaining carriers is
stepped up or down by the power specified in the
:BB:MCCW:EDIT:CARR:POW:STEP
command.
Parameters:
<Start> float
Range:
-80 to 0
Increment: 0.01
*RST:
0
Example: BB:MCCW:EDIT:CARR:POW -50 dB
sets the power of the carrier to -50 dB.
Manual operation: See "Power Start" on page 428
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STARt <Start>
Selects the first carrier in the carrier range to which the settings with
the
:BB:MCCW:EDIT:CARR:...
commands shall apply.
Parameters:
<Start> integer
Range:
0 to 8191
*RST: 0
Example: BB:MCCW:EDIT:CARR:STAR 4
the carrier range starts at carrier 4.
Manual operation: See "Carrier Start" on page 428
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STATe <State>
Switches all the carriers in the selected carrier range on or off.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
1
Example: BB:MCCW:EDIT:CARR:STAT ON
sets all the carriers in the carrier range to ON.
Manual operation: See "Carrier State" on page 428
[:SOURce<hw>]:BB:MCCW:EDIT:CARRier:STOP <Stop>
Selects the last carrier in the carrier range to which the settings with
the
:BB:MCCW:EDIT:CARR:...
commands shall apply.
SOURce Subsystem