R&S SMJ100A, Руководство по эксплуатации, Страница: 573 / 874

Remote Control Commands
R&S
®
SMJ100A
557 Operating Manual 1403.7458.32 ─ 14
Example: OUTP:PROT:TRIP
Queries the state of the protective circuit for RF output A.
Response: 0
The protective circuit has not tripped.
Response: 1
The protective circuit has tripped.
Usage: Query only
Manual operation: See "Overload" on page 232
:OUTPut<hw>[:STATe] <State>
Activates and deactivates the RF output signal (RF ON / RF OFF).
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example:
OUTP OFF
deactivates the RF output.
Manual operation: See "RF On" on page 200
:OUTPut<hw>[:STATe]:PON <Pon>
Selects the state of the RF output when the instrument is switched on.
Parameters:
<Pon> OFF | UNCHanged
OFF
deactivates the output when the instrument is switched on (RF
OFF).
UNCHanged
restores the initial state of the RF output before the last turn off.
sets the output status as it was when the instrument was
switched off.
*RST:
UNCHanged
Example: OUTP:PON OFF
RF output A is deactivated when the instrument is switched on.
Manual operation: See "Power-On State - RF Signal" on page 220
:OUTPut:USER<ch>:SOURce <Source>
The command selects the signal for the specified USER interface.
Some signals which can be applied at the USER interface are permanently assigned
and some are assigned using a dedicated command (e.g.
OUTP:CW:SOURce
for the
CW control signal).
OUTPut Subsystem