R&S SMJ100A, Руководство по эксплуатации

Страница: 535 / 874

Remote Control Commands
R&S
®
SMJ100A
519 Operating Manual 1403.7458.32 ─ 14
Example: BERT:STAR
starts a continuous measurement.
Usage: Event
Manual operation: See "Mode" on page 189
:BLER:STATe <State>
:BERT:STATe <State>
Switches the measurement on/off. Depending on the selected mode, either a continu-
ous measurement (
BERT|BLER:SEQ AUTO
) or a single measurement
(
BERT|BLER:SEQ SING
) is carried out. A single measurement must be triggered
(
:TRIG:BERT|BLER
).
These commands are automatically set to ON by
BERT:STARt
or
BLER:STARt
and to
OFF by
BERT:STOP
or
BLER:STOP
.
Parameters:
<State> 0 | 1 | OFF | ON
*RST:
0
Example: BERT:SEQ SING
selects a single measurement.
BERT:STAT ON
switches the BER measurement on.
Example: TRIG:BERT
starts a single measurement.
Manual operation: See "State" on page 186
:BLER:STOP
:BERT:STOP
Stops an ongoing measurement.
These commands automatically set
BERT:STATe
or
BLER:STATe
to OFF
.
Example: BERT:STOP
stops the measurement. To start a new measurement, the BER
measurement must be switched on again by
BERT:STATe ON
.
Usage: Event
Manual operation: See "Terminated By" on page 187
BERT and BLER Subsystems