R&S SMJ100A, Руководство по эксплуатации, Страница: 407 / 874

Instrument Function
R&S
®
SMJ100A
391 Operating Manual 1403.7458.32 ─ 14
Sine Test Signals
To access the "Sine Test Signals" dialog, in the "ARB MOD" dialog set the parameter
"Create Test Signal" to Sine and press "Create Test Signal".
The menu can be used to configure a sinusoidal test signal. A sine wave is generated
on the I path, and a sine wave of the same frequency but phase-shifted is generated
on the Q path.
The signal actually set is displayed in graphical form in the center of the menu.
Frequency (Sine Test Signal)
Enters the frequency of the test signal.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:FREQuency
on page 595
Samples per Period (Sine Test Signal)
Enters the number of sample values required from the sine wave per period.
The resulting clock rate must not exceed the maximum ARB clock rate (see data
sheet). The number of sample values is automatically restricted by reference to the set
frequency.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:SAMPles
on page 596
Phase Offset Q (Sine Test Signal)
Enters the phase offset of the sinewave signal on the Q channel relative to the sinew-
ave signal on the I channel.
Remote command:
[:SOURce<hw>]:BB:ARBitrary:TSIGnal:SINE:PHASe
on page 596
Baseband Signal - Baseband Block