R&S SMJ100A, Руководство по эксплуатации

Страница: 186 / 874

Instrument Function
R&S
®
SMJ100A
170 Operating Manual 1403.7458.32 ─ 14
5.3.1 Graphics Settings Menu
The "Graphics Settings" menu for selecting the graphical display of the output signal is
opened either in the "Graphics" function block or in the menu with the same name
which is opened using the MENU key.
The signal display can be selected and activated in the menu.
With two-path instruments, the settings for the two paths can be entered separately.
The signals can be displayed simultaneously in two separate windows.
State
Activates the selected graphical display.
After activation, the diagram selected with "Mode" is displayed in the block diagram.
At the bottom of each graphics window there are several buttons for freezing and
zooming the display and for activating a reference curve.
For more information, see Chapter 5.3.2, "Bar of Graphics Window" , on page 172.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:STATe
on page 668
Smart Graphics
Activates the "smart graphics".
The graphic is displayed in a small window which is roughly the size of a block. These
windows are displayed permanently in the block diagram until they are deactivated,
and allow basic checking of the signal. They do not contain any buttons.
Remote command:
[:SOURce<hw>]:BB:GRAPhics:SMARt:STATe
on page 667
Mode
Selects the graphical signal display. The display is not shown until it has been activa-
ted with "Status On".
The individual signal displays are described in the Chapter 5.3.3, "Signal Displays" ,
on page 174.
Graphical Display - Graphics