R&S SMJ100A, Руководство по эксплуатации, Страница: 149 / 874

Instrument Function
R&S
®
SMJ100A
133 Operating Manual 1403.7458.32 ─ 14
●
"Baseband Assembly"
Operation Time / h
Displays the operation time in hours.
Remote command:
:DIAGnostic:INFO:OTIMe?
on page 527
Power On Count
Displays the number of power-on.
Remote command:
:DIAGnostic:INFO:POCount?
on page 527
Assembly
The tables list the installed assemblies.
"Assembly"
Assembly name
"Part Number" Part Number of assembly
"Serial Number"
Serial Number of assembly
"Revision" Revision state of assembly
"Slot" Indicates whether the assembly is connected to the serial bus or PCI
bus.
Remote command:
:DIAGnostic<hw>:BGINfo?
on page 526
5.2.3.3 Software / Options
The "Software/Options" dialog shows the firmware version of the instrument software
as well as all installed hardware and software options.
Software options purchased at a later stage can be activated with a keycode. The acti-
vation code is supplied with the software option. How to install options is described in
Chapter 4 of the Service Manual (supplied with the instrument).
The installation of hardware options purchased at a later stage is also described in
Chapter 4 of the Service Manual (supplied with the instrument). Most hardware options
need to be installed at an authorized Rohde&Schwarz service shop.
To access the "Software/Options" dialog, select "System" and press the SETUP or
MENU key.
The menu is devided into the following sections:
●
"Firmware"
●
"Hardware Options"
●
"Software Options"
●
"WinIQSIM"
●
"Loaded Modules"
General Instrument Settings