DVB-T2 Configuration and Settings
R&S
®
SMCVB-K164
33
User Manual 1179.0974.02 ─ 02
PLP <num> table
Displays individual parameters for each PLP
<num>
. The table displays information of
up to 20 PLPs with
<num>
ranging from 0 to 19.
Note:
Numbering in remote control commands.
The suffix
PLP<ch>
ranges from 1 to 20, the PLP number
num
ranges from 0 to 19.
See
"To configure "PLP Info" "Mode & Stream" parameters"
PLP ID (Hex) ← PLP <num> table
Sets the PLP ID. The PLP ID has to be unique.
You can set the PLP ID in hexadecimal representation.
Remote command:
[:SOURce<hw>]:BB:T2DVb:PLP<ch>:ID
PLP Group ID (Hex) ← PLP <num> table
Sets the PLP group ID for multi-PLP, i.e. the number of PLPs is greater than 1.
Multi-PLP requires number of PLPs > 1, see
Remote command:
[:SOURce<hw>]:BB:T2DVb:PLP<ch>:GROup
PLP Type ← PLP <num> table
Sets the PLP type.
The type depends on the number of PLPs in the setup.
"Common"
Requires a multi-PLP setup.
Common PLP of the PLP Group.
"D. Type 1"
Data type 1.
Fixed for a single-PLP setup. Configurable for a multi-PLP stream.
"D. Type 2"
Requires a multi-PLP setup.
Data type 2.
Remote command:
[:SOURce<hw>]:BB:T2DVb:PLP<ch>:TYPE
BB Mode ← PLP <num> table
Defines the baseband mode.
"HEM"
High efficiency mode.
"NM"
Normal mode.
Remote command:
[:SOURce<hw>]:BB:T2DVb:PLP<ch>:BB_Mode
ISSY ← PLP <num> table
Displays the
state.
"OFF"
ISSY is not active. ISSY indicator field is 0.
"Short"
ISSY is active. ISSY indicator field is 1. The synchronizer uses a
short
.
Mode & Stream Settings