Remote-control commands
R&S
®
SMCVB-K157
51
User Manual 1179.4686.02 ─ 01
Return values:
<InpSigUsefull>
float
Range:
0 to 999999999
Increment: 0.001
*RST:
0
Example:
See
Example "Configuring general input signal properties"
Usage:
Query only
Manual operation:
See
5.2.3
Test signal commands
Example: Configuring test signal properties
SOURce1:BB:DVBC:SOURce TEST
SOURce1:BB:DVBC:TESTsignal TTSP
// Sets a test TS packet as test signal.
********************************************************************************
// Alternatively, set more specific test signals with PRBS parts within the
// test packet.
********************************************************************************
SOURce1:BB:DVBC:TESTsignal PBDE
// Inserts the PRBS sequence before the differential encoder.
SOURce1:BB:DVBC:TESTsignal PBEM
// Inserts the PRBS sequence after the mapper.
********************************************************************************
// Configure test signal properties.
********************************************************************************
SOURce1:BB:DVBC:TSPacket H184
SOURce1:BB:DVBC:PIDTestpack NULL
SOURce1:BB:DVBC:PID?
// Response in decimal representation: "8191"
// Response in hexadecimal representation: "1FFF"
SOURce1:BB:DVBC:PIDTestpack VAR
SOURce1:BB:DVBC:PID 4607
// Corresponds to "11FF" in hexadecimal representation.
SOURce1:BB:DVBC:PAYLoad PRBS
SOURce1:BB:DVBC:PRBS P23_1
[:SOURce<hw>]:BB:DVBC:TSPacket
.................................................................................52
[:SOURce<hw>]:BB:DVBC:PIDTestpack
.............................................................................52
......................................................................................... 52
..................................................................................52
...................................................................................... 53
Input commands