Instrument Function
R&S
®
SMB100A
232
Operating Manual 1407.0806.32 ─ 21
Edit Pulse Train Data
Opens an editor allowing you to enter the "On-Time / OFF-Time" value pairs in a table.
In addition, you can assign a repetition rate to each pair. Based on these values, the
instrument then generates the pulse train signal. You can enter any number of value
pairs and save your list in a file. The file name is displayed in the header of the dialog.
"ON-Time/
μ
s"
Determines the length of the respective pulse (signal is high).
Remote command:
[:SOURce<hw>]:PULM:TRAin:ONTime
"OFF-Time/
μ
s" Determines the time length, the signal level of the pulse remains low.
Remote command:
[:SOURce<hw>]:PULM:TRAin:OFFTime
"Count"
Sets the number of repetitions for each pulse ("ON-Time/
μ
s"/"OFF-
Time/
μ
s" value pair).
Tip:
If you set "Count = 0", the corresponding value pair is ignored in
the pulse sequence. With this function you can skip value pairs indi-
vidually, without deleting them from the table. This allows re-enabling
a value pair by entering a number unequal to zero.
Remote command:
[:SOURce<hw>]:PULM:TRAin:REPetition
"Goto"
Selects row for editing.
If Goto row is selected, a window opens for entering the requested
row.
(it is not possible to change individual positions of the list)
"Edit"
Opens a menu containing editing functions.
"Insert Row"
Inserts a new row before the marked row.
Modulation Generator and LF Output