R&S SMA100B, Руководство пользователя

Страница: 423 / 581

Remote Control Commands
R&S
®
SMA100B
408 User Manual 1178.3834.02 ─ 03
Example: See Example "Setup an LF sweep" on page 403.
Manual operation: See "State (LF frequency sweep)" on page 97
[:SOURce<hw>]:LFOutput:FREQuency:STOP <Stop>
[:SOURce<hw>]:LFOutput:FREQuency:STARt <Start>
Sets the start/stop frequency for
[:SOURce<hw>]:LFOutput:FREQuency:MODE
SWEep
.
Parameters:
<Start> float
Range:
0.1 Hz to 1 MHz
Increment: 0.1
*RST:
1 KHz
<Stop> float
Range:
0.1 Hz to 1 MHz
Increment: 0.1 Hz
*RST:
100 KHz
Example: See Example "Setup an LF sweep" on page 403.
Manual operation: See " Start Frequency/Stop Frequency " on page 129
[:SOURce]:LFOutput:OFFSet <Offset>
Sets a DC offset at the LF Output.
Parameters:
<Offset> float
Range:
depends on lfo voltage
Increment: 0.001
*RST:
0
Example: See Example "Configuring the LF generator" on page 404.
Manual operation: See "DC-Offset" on page 103
[:SOURce]:LFOutput:SOURce <Source>
Defines which signal is output
SOURce Subsystem