R&S RTO6, Руководство пользователя

Страница: 485 / 2677

Protocol analysis
R&S
®
RTO6
485 User Manual 1801.6687.02 ─ 05
Triggering on a trigger event sequence is not supported, and holdoff settings are
not available.
●
Protocol decoding: The digitized signal data is displayed on the screen together
with the decoded content of the messages in readable form, and the decode
results are listed in a table.
●
Search on decoded signal data: For most serial protocols, you can find various
events in the decoded data. You can find the same events that you can trigger on,
and even many more, because several event types can be combined. Thus, you
get the results for the complete acquisition cycle.
13.1.1 Setup - general settings
For all protocols, configuration starts with the selection of the serial bus and the proto-
col.
Table 13-1: Configuration settings are protocol-specific. They are described in the related chapters:
K510
Low speed serial buses
I²C Chapter 13.2.2, "I²C configura-
tion"
, on page 496
Custom: Manchester / NRZ Chapter 13.6.2, "Custom: Man-
chester / NRZ configuration"
,
on page 549
UART Chapter 13.4.2.1, "UART configu-
ration settings"
, on page 521
SPI Chapter 13.3.2, "SPI configura-
tion"
, on page 510
Audio Chapter 13.5.2, "Audio configura-
tion"
, on page 531
K520
Automotive serial buses
low speed
CAN, CAN FD Chapter 13.7.2, "CAN and CAN
FD configuration"
, on page 579
LIN Chapter 13.8.2, "LIN configura-
tion"
, on page 606
FlexRay Chapter 13.9.1.1, "FlexRay con-
figuration"
, on page 618
CXPI Chapter 13.11.2, "CXPI configura-
tion"
, on page 667
SENT Chapter 13.10.2.1, "SENT config-
uration"
, on page 639
RTO6-K530
Aerospace buses
MIL-1553 Chapter 13.12.2, "MIL-STD-1553
configuration"
, on page 688
ARINC 429 Chapter 13.13.2, "ARINC 429
configuration"
, on page 703
SpaceWire Chapter 13.14.2, "SpaceWire con-
figuration"
, on page 715
Basics of protocol analysis