Preparing for use
R&S
®
RTO6
22
Getting Started 1801.6670.02 ─ 03
4.7
Switching on or off
The instrument is switched on or off with the power switch and the [Power] key.
The [Power] key is located in the bottom left corner of the front panel. The power
switch is located at the rear panel of the instrument.
Table 4-1: Overview of power states
Status
LED
Power switch
Off
(unlighted)
[0] (off)
Standby
yellow
[I] (on)
Ready
green
[I] (on)
To switch on the product
The product is off but connected to power.
1. Set the switch on the power supply to position [I].
The power key on the front panel lights up.
2. Press the [Power] key on the front panel.
The instrument performs a system check, boots the operating system, and
then starts the R&S
RTO6 firmware.
The [Power] key turns green and the illuminated keys on the front panel light
up. If the previous session was terminated regularly, the oscilloscope uses the
last settings.
Before you start measurements, be sure to comply with the warm-up phase
specified in the data sheet.
To shut down the product
The product is in the ready state.
► Press the [Power] key.
All current settings are saved, and the software shuts down. The [Power] key
turns yellow. The standby power supplies only the power switch circuits.
The "Exit" icon in the "Menu" shuts down only the firmware application. To shut
down the instrument completely, use the [Power] key.
Switching on or off
