Measurements
R&S
®
RTC1000
84
User Manual 1335.7352.02 ─ 04
● Fall time (t
f
)
The following measurement values are displayed at the bottom of the screen:
● RMS value
● Peak to peak voltage
● Amplitude
● Pos. pulse width
● Pos. duty ratio
● Period
● Frequency
● Number of positive /slopes
● Neg. pulse width
● Neg. duty ratio
3. Press the [QUICK VIEW] key again to switch off the function.
The six measurement parameters on the bottom right can be changed using the
[AUTO MEASURE] key, see
Chapter 7.3, "Automatic Measurements"
7.2
Cursor Measurements
Cursor measurements are often used with an oscilloscope. Depending on the mea-
surement type, up to three cursor lines are available.
To move cursors:
1. To select the cursor line, press the Universal knob in the Cursor/Menu section.
2. To position the cursor line, turn the Universal knob.
The measurement results are displayed at the bottom of the screen.
If "n/a" is displayed, the measurement is not applicable to the signal. For instance, this
can be the case for a voltage measurement on a "POD" because only logic states with-
out voltage reference are displayed.
If "?" is displayed, the display does not show a complete measurement result. For
instance, the period to be measured is not completely displayed and cannot be identi-
fied.
7.2.1
Cursor Measurement Settings
► Press the [CURSOR MEASURE] key in the Cursor/Menu section.
Cursor Measurements