System Settings
R&S
®
NRX
128
User Manual 1178.5566.02 ─ 05
12.1.1
Network Settings
Access: [System]
> "Connections"
> "Network"
Contains the settings for integrating the R&S NRX in a network. There are two meth-
ods to establish a network connection:
●
R&S NRX and computer are connected to a common network (infrastructure net-
work).
●
R&S NRX and computer are connected only over the switch (peer-to-peer net-
work).
Connection errors can affect the entire network. If your network does not support
DHCP, or if you choose to disable dynamic TCP/IP configuration, assign a valid
address information before connecting the R&S NRX to the LAN. Contact your network
administrator to obtain valid IP addresses.
After integrating the R&S NRX into a network, you can set up the following connec-
tions:
●
Remote control connection to control the R&S NRX using SCPI commands.
See
●
Remote desktop connection for remote operation or file transfer.
See
Chapter 5.2, "Remote Operation"
The "Network" dialog is divided into the following tabs:
........................................................................................... 129
...............................................................................................130
.................................................................................................131
.................................................................................................131
........................................................................................... 131
Connections