Preparing for Use
R&S
®
NRPxxS(N)
16
User Manual 1177.5079.02 ─ 10
1
= R&S NRP
‑
Z5 sensor hub
2
= External power supply unit (supplied)
3
= Power cable (supplied)
4
= AC power supply
5
= USB cable (supplied)
6
= Computer with USB host interface
7, 8
= BNC cable (optional, not supplied)
9
= Trigger source (optional)
10
= Triggered device (optional)
11-14 = R&S NRP
‑
ZK6 cable
15
= Host interface connector
16
= R&S NRPxxS(N) power sensor
17
= Signal source
Incorrectly connecting/disconnecting the R&S NRPxxS(N) power sensors can damage
the power sensors or lead to erroneous results.
Ensure that you connect/disconnect your power sensor as described in
1. Connect the cables as shown in
a) Connect the R&S NRP
‑
ZK6 cable to the power sensor.
b) Connect the power sensors to the R&S NRP
‑
Z5 sensor hub. You can connect
up to four sensors.
c) Connect the R&S NRP
‑
Z5 to the computer.
d) Connect the power sensors to the signal source.
e) Connect the delivered external power supply unit to the R&S NRP
‑
Z5 and to an
AC supply connector.
f) Connect the trigger input of the R&S NRP
‑
Z5 with a BNC cable to the trigger
source (optional).
g) Connect the trigger output of the R&S NRP
‑
Z5 with a BNC cable to the trigger
device (optional).
2. On the computer, start a software application to view the measurement results.
Chapter 5, "Operating Concepts"
3.5.2
Setting Up a LAN Connection
Requires power sensors with networking capabilities, the R&S
NRP LAN power sen-
sors.
This section describes how to connect the sensor to a LAN network and configure the
LAN interface for establishing a connection.
Connecting to a Computer