R&S NRP2, Руководство пользователя

Страница: 286 / 437

Remote Control - Commands
R&S
®
NRP2
268 User Manual 1173.9157.02 ─ 03
[SENSe<[1]..4>]:CORRection:SPDevice:SELect
selects one of these tables.
The
[SENSe<[1]..4>]:CORRection:SPDevice:STATe ON
command activates
measured-value correction.
Parameters:
<NR1> int_value
*RST:
depending on sensor
[SENSe<[1]..4>]:CORRection:SPDevice:STATe <state>
Instructs the sensor to perform a measured-value correction by means of one of the
stored S-parameter tables (S-parameter device).
Parameters:
<state> ON | OFF
*RST:
depending on sensor
[SENSe<[1]..4>]:FREQuency[:CW] <frequency>
[SENSe<[1]..4>]:FREQuency[:FIXed] <frequency>
Informs the R&S NRP2 about the frequency of the power to be measured since this
frequency is not automatically determined. The frequency is used to determine a fre-
quency-dependent correction factor for the measurement results.
Parameters:
<frequency> float_value
Range:
depending on sensor
*RST: depending on sensor
Default unit: HZ
[SENSe<[1]..4>]:FUNCtion[:ON] <mode>
Sets the sensor to the selected measurement mode.
In remote control, the timing (
SENS:TIM:EXCL:STAR
and -
:STOP)
and the trigger sys-
tem of all measurement modes (except the Burst mode) are user-selectable.
Note:
To increase measurement accuracy, the sensors measure each signal twice in the Burst,
Timeslot and Trace measurement modes (exception: in the Trace mode, with
SENS:TRAC:REAL ON
). As long as the trigger system is set to internal or external trig-
gering, this is usually of no importance to the user. If
TRIG:SOUR HOLD
or
BUS
is used,
however, then each measurement must be triggered twice (with
*TRG
or
TRIG:IMM
).
Error messages:
24 "Sensor mode not supported" : A sensor does not support a measurement mode.
28 "Sensor not idle" : The sensor is not in the IDLE state.
-151 "Invalid string data" : An invalid parameter was transmitted for <string>.
SENSe (Sensor Commands)