R&S NRP2, Руководство пользователя

Страница: 187 / 437

Remote Control Fundamentals
R&S
®
NRP2
169 User Manual 1173.9157.02 ─ 03
The "VISA address string" suitable for the instrument is displayed in the dialog box.
The R&S
NRP2 has a fixed, unchangeable address comprising the manufacturer
number, an instrument number and the serial number of the instrument.
USB::<vendor ID>::<product ID>::<serial number>[::INSTR]
VXI11 configuration:
1. Select "VXI11" as the active interface.
2. Choose "Manual" or "DHCP" IP address configuration.
If "DHCP" is chosen, IP address, subnet mask and gateway address are retrieved
from a DHCP server. The DCHP server must be available in the network. No further
steps are required.
3. If "Manual" is selected, enter the "IP address" assigned by the network administrator
to the R&S NRP2.
In large networks, specification of additional addresses may be required for link setup,
e.g. gateway and subnet mask, which are known to the network administrator.
Ethernet configuration:
1. Select "Ethernet" as the active interface .
2. Choose "Manual" or "DHCP" IP address configuration.
If "DHCP" is chosen, IP address, subnet mask and gateway address are retrieved
from a DHCP server. The DCHP server must be available in the network. No further
steps are required.
3. If "Manual" is selected, enter the "IP address" assigned by the network administrator
to the R&S NRP2.
In large networks, specification of additional addresses may be required for link setup,
for example. gateway and subnet mask, which are known to the network adminis-
trator.
4. Enter the port address ("PortNo"). Incoming connections from a controller have to
use this port number in order to establish a connection to the R&S NRP2.
5. Define the IEEE protocol mode. For example select "IEEE 488.0" mode in order to
use raw socket communication. See also
​
chapter A.3, "Ethernet interface" ,
on page 355.
5.2.2 Hardware Requirements
Risk of network failure
Before connecting the instrument to the network or configuring the network, consult your
network administrator. Errors may affect the entire network.
Connecting a Controller to the Base Unit