Remote commands to perform measurements in MSRA mode
R&S
®
FSWP-B1
73
User Manual 1177.5862.02 ─ 09
Application
<ChannelType> Parameter
Default Channel Name*)
Transient Analysis
(R&S
FSWP-K60)
TA
Transient Analysis
Vector Signal Analysis
(R&S
FSWP-K70)
DDEM
VSA
Note: the default channel name is also listed in the table. If the specified name for a new channel already
exists, the default name, extended by a sequential number, is used for the new channel.
INSTrument:MODE
<OpMode>
The operating mode of the R&S
FSWP determines which applications are available
and active. Whenever you change the operating mode, the currently active channels
are closed. The default operating mode is Signal and Spectrum Analyzer mode, how-
ever, the presetting can be changed.
(See the "Instrument Setup" chapter in the R&S
FSWP User Manual).
Parameters:
<OpMode>
SANalyzer
Signal and Spectrum Analyzer mode
MSRanalyzer
Multi-Standard Radio Analysis (MSRA) mode
*RST:
SAN
Example:
INST:MODE MSR
Switches to Multi-Standard Radio Analysis (MSRA) mode.
Manual operation:
See
"Switching the operating mode"
INSTrument:REName
<ChannelName1>, <ChannelName2>
This command renames a channel.
Setting parameters:
<ChannelName1>
String containing the name of the channel you want to rename.
<ChannelName2>
String containing the new channel name.
Note that you cannot assign an existing channel name to a new
channel. If you do, an error occurs.
Channel names can have a maximum of 31 characters, and
must be compatible with the Windows conventions for file
names. In particular, they must not contain special characters
such as ":", "*", "?".
Example:
INST:REN 'PhaseNoise','PNO'
Renames the channel with the name 'PhaseNoise' to 'PNO'.
Usage:
Setting only
Activating MSRA measurements